SP bindings "Setup with boots"

Please watch the video.
It's easy to see this.
Please adjust to your personal taste.
In the case of Atsushi Ishikawa
The ankle strap and toe cup are set tightly.
When you put it on, put your boots up to the toe cup and raise the high back.Since it is a little tight, it can be worn while pushing it in with a high back, so it requires a little trick, but it has a very high response, and the degree of adhesion with the boots is improved, so you can demonstrate high performance.Ideal for those who value response.
The ankle strap is also set tightly.Every time, I loosen the Evo buckle, put it on, and tighten it further before slipping.Although it is a hassle, "Atsushi Ishikawa" makes such a setting because it can demonstrate extremely high performance.
In the case of Saori Okada
I chose the toe cup not too tight and not too loose because I like a good hold.I choose to put the boots in the toe cup smoothly and make the high back smooth.The ankle strap also has a hold that does not adjust the Evo buckle, so it can be attached smoothly.She likes to hold a little tight with an Evo buckle when riding big kickers or high speeds."Saori Okada" has such a setting.

SP Bindings require boot and strap settings before slipping.
Loosen the ankle strap and toe cup before inserting the boots.

Raise the highback and raise the highback lever.Set it to a slippery state.

Push in the toe cup and set it exactly.
Adjust the location so that the ankle strap is also in the middle, and adjust it with the Evo buckle.

Remove the boots and set the toe cup a little narrower.
It is just right to narrow it by about 2 memories on each side.Please adjust according to your hold.If you set it tightly, the hold feeling will be very high and the riding performance will be high, but it will be a little difficult to wear.On the contrary, if you set it loosely, it will be easier to wear, allowing loose riding, and it is ideal for fan riding.